You will get a bunch of numbers followed by 'usecs' or 'usec'.
Make sure you have copied the signal you want into a word pad for easier reference.
It will look something like this:
500 usec, 300 usec
600 usec, 1200 usec
But there will be a lot more numbers than that.
Now in the program you will see this quite a few times:
delayMicroseconds();
pulseIR();
You want to take the first number and put it in the parentheses in delayMicroseconds('here'); value
And you want to take the second number from the same line as the one of the delayMicroseconds(); value and put it in the parentheses of pulseIR(); value.
Example:
Say you get this on the serial monitor:
OFF ON
1660 usec, 580 usec
1640 usec, 560 usec
You want to put the corresponding values in their corresponding areas.
Such as:
delayMicroseconds(1660);
pulseIR(580);
delayMicroseconds(1640);
pulseIR(560);
It is pretty damn easy.
Once you get the codes you want, open the IR_SEND.pde file in the Arduino program and then put the values that you got from the serial monitor between the parentheses doing it the same way I showed you how to do it.
The next step will show an example of how I did this with a Comcast remote.
Make sure you have copied the signal you want into a word pad for easier reference.
It will look something like this:
500 usec, 300 usec
600 usec, 1200 usec
But there will be a lot more numbers than that.
Now in the program you will see this quite a few times:
delayMicroseconds();
pulseIR();
You want to take the first number and put it in the parentheses in delayMicroseconds('here'); value
And you want to take the second number from the same line as the one of the delayMicroseconds(); value and put it in the parentheses of pulseIR(); value.
Example:
Say you get this on the serial monitor:
OFF ON
1660 usec, 580 usec
1640 usec, 560 usec
You want to put the corresponding values in their corresponding areas.
Such as:
delayMicroseconds(1660);
pulseIR(580);
delayMicroseconds(1640);
pulseIR(560);
It is pretty damn easy.
Once you get the codes you want, open the IR_SEND.pde file in the Arduino program and then put the values that you got from the serial monitor between the parentheses doing it the same way I showed you how to do it.
The next step will show an example of how I did this with a Comcast remote.
MENGHIDUPKAN LAMPU DENGAN REMOTE PROJECT TRANDUSER MENGHIDUPKAN LAMPU MENGGUNAKAN REMOTE. Disusun oleh: Kelompok 7(TK-1A) Dina Nur Handayani (3.33.16.0.07) POLITEKNIK NEGERI SEMARANG TAHUN 2016. PENDAHULUAN I.I Latar Belakang. Kemajuan teknologi.